4.9 (626) · $ 27.00 · In stock
Hello, I recently bought a Printrbot Play, and I’m experiencing some problems with my first layer. The first layer looks acceptable for small objects, but when I print some bigger objects (with a greater surface) it just looks terrible. As you can see on the picture, it looks like the infill is way to big to fit inside the perimeters of the first layer. It is actually crossing the bottom perimeter, and causing the layer to “wave”. The small square on the left has this issue also, but less
3D Printing Quality Problems: Why is the First Layer Rough?
Troubleshooting 3D prints, first layer issues
Warped Prints? Try these Quick Tips with Your Next 3D Print
First layers bubbles issue - LulzBot Mini - LulzBot
Terrible first layer - 3D Printing / 3D Printers - Talk Manufacturing
Bad adhesion or bad bed levelling? - Troubleshooting - Bambu Lab Community Forum
Přímá viditelnost Milovaný Děkuji 3d print first layer issues lékárna Start zbytky
First Layer Challenges - Getting Started - Snapmaker: where creation happens
First layer looks always horrible in the middle of a larger area – Assembly and first prints troubleshooting – Prusa3D Forum
Terrible first layer - 3D Printing / 3D Printers - Talk Manufacturing
Curious About 3D Printing? Here Are Some Tips Before You Dive In
Curling support first layer – Assembly and first prints troubleshooting – Prusa3D Forum